Ambit
From The Black OP Security Wiki
|
|
This is not a guide on install Haxorware, this is a guide on configuring Haxorware on a modem that's already been chipped, flashed and is running Haxorware.
Connect your modem via Ethernet and navigate to http://192.168.100.1
This should show the Haxorware main page - if it doesn't you need to invest in a ambit 256 modem. You can buy them flashed for around £20-30
Finding the MAC
Download DHCPSniffer, connect your haxorware modded modem via Ethernet, connect the virgin coax.
Note: You must perform this scan 3-4 miles away from where you intend to use the box otherwise someone else in that area might be using the same MAC which would cause them to conflict and not work.
Configuring Haxorware
- HAXOWARE UNFORCED TUTORIAL*
In network connections, set your network adaptor too-
IP Address: 192.168.100.10 Subnet Mask: 255.255.255.0 Gateway: 192.168.100.1 Leave any other settings alone and hit OK
OPEN INTERNET EXPLORER and press 192.168.100.1 in the address bar and it should take you to the Haxorware page to sort out the settings, cool well the settings are as follows-
Configuration:
Settings-
General:
Factory Mode - Unticked Disable Firmware Upgrades - Ticked Force Network Access - UNTICKED Tftp Enforce Bypass - ticked Ignore Unknown Messages-UNTICKED Disable IP Filters on Startup - ticked
Administration:
Control Panel IP Address - 192.168.100.1 DHCP Server - Ticked Username - admin (change the password for added security) Password - admin (change the password for added security)
Press Save
Frequency Settings:
Annex - Both Plan - European Preferred DS Freq 1 - 402750000 (this is for NTL), 586750000 (this is for cable and wireless), 331000000 (this is for telewest) 2 and 3 - 0 Upstream channel - dont change (will change on its own)
Press Save
Addresses:
HFC MAC - Your Mac Address Ethernet Mac - Dont touch USB MAC - Copy your HFC MAC address, only this time change the last letter/number on it to 1 letter/number higher. Serial Number - Dont Touch certificate type - motorola eurodocis
Press Save
Config File: LEAVE EMPTY
Server IP: LEAVE EMPTY
Autoserve disabled
Stored cfg/store new config - no need to do anything here.
Press Save
Baseline Privacy:
BPI disabled
All the rest in the Baseline privacy section will not be touched.
Press Save, basically press save in every page when ever you change settings otherwise they wont stick.
Now put your IP options back to - Obtain IP address Automatically and reb0ot your modem and attach your cable feed.
And that is that, that should be everything done and you should now be able to get online.
http://www.techwatch.co.uk/forums/71659-haxorware-settings.html#post405826
